Further Thoughts on the SX-70

3 02 2014

There was going to be a write up on shooting infrared with the XA2 here, but technical issues meant that I gave up about 6 shots in. What I think the problem was, was having the flash set to ‘full’, which I’ve since read, is a manual setting, and so the inbuilt meter on the XA2 will set the shutter speed as if the flash weren’t attached. Not good in a very dark club. The flash fired for the shots, so I’m hopeful that with the lack of ambient light, there might be a kind of rear curtain flash effect to the shots, and not a total blur. But the experiment is now postponed until next weekend, when I’m at another gig in the same venue, so, we’ll see.

I’m a couple of weeks into shooting with the SX70 now, and I’m completely in love. I’ve stocked up on film, and bought a cable release for it aswell. I’ve had all sorts of ideas, and after kind of recklessly blowing through the first pack, I’m being a little more considerate with my shots now.

shot2

When I loaded up the first pack, I was too giddy about playing with it to remember to install the frog tongue which J also got for me. It’s a small piece of rolled back lightproof material, which you load into the front of the camera along with the film pack, providing protection from the light when the shot ejects. Although the more recent Impossible Project film has much improved with regards to sensitivity after exposure, it still takes a little while (30-40 minutes) to fully develop,and during this time, it’s really advisable to keep it out of the light. If I’m home, I slide it into a book or under my laptop. If I’m out and about, I try to remember to have a journal with me to slip it inside in my bag. Failing that, the backing material is just sturdy enough to be safe inside a pocket,if you’re careful.

As it turns out, it’s perfectly possible to install the frog tongue mid-pack, and if my first experience is representative, the only way you can use it. Once I had it installed, and after checking it over, I loaded a film cartridge into the camera, closed it, and waited for the dark slide to eject. Nope. The dark slide jammed halfway out, meaning some jimmying with a narrow screwdriver to slide it back enough to open up the camera again. After checking the positioning of the frog tongue, subsequent efforts yielded the same result. I can’t be certain though if it’s that the dark slide is too thick to eject correctly, or that I had the tongue installed badly to begin with and the second attempts were because the rear of the dark slide had become too mangled for the camera to shove it out. I ended up wasting a shot when I had to discard the dark slide, but beyond that, the tongue has been working very well.
20140203-114843.jpg

20140203-114852.jpg

20140203-114900.jpg

On to the cable release.
I bought one from the Impossible Project, since I was ordering some film anyway. I’ve seen a few DIY tutorials, but at £16 it isn’t expensive, and my electronics skills really aren’t up to much.

It connects to the camera via the two tiny holes to the size of the shutter button. One end is a two pin connector, the other a simple plastic box housing a button, with two metres of cable inbetween.

20140128-051637.jpg
The only real issue, if you’re using it for self portraits, is focussing correctly. Using flash, the aperture should be firing at around f22, so there’s a little margin for error. I placed a light stand in front to focus on, then positioned myself in its place to take the shot. It seems to have worked out fine.

20140128-052117.jpg
Excuse the mop hair and owl pyjamas 🙂

Because I am a great lover of fiddling, changing and creating, I’ve since started experimenting with altering the image, in terms of emulsion manipulation, and adding alternative media. There’s something both nerve wracking but also exciting about changing an instant photograph in this way, similarly to the alteration of a negative. You can’t go back once you’ve changed it. Once it’s done, the original is destroyed, to make way for what is a completely new piece.

shot1

sp1

sp2

My ideas have begun to filter into specific project ideas now, and I’m hoping to start working towards my next self-published work, centred around instant film, within the next few weeks, so hopefully my vague experiments will start to take on a little more shape and meaning. The ‘lets try this and just see what happens’ approach is fun, but at around £2.50 per shot, not a sustainable way to work with this film!

For anyone interested, I’m posting my ongoing experiments and general instant shots on Tumblr at Blank Borders.

Advertisements

Actions

Information

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s




%d bloggers like this: